![]() See Broadcom wireless and makepkg for more information. If the wireless interface is still not listed, you will need to compile the b43-firmware AUR package on another computer with pacman installed, put the generated package file on a second USB storage device, install the package within the Arch live environment and then load the b43 module, much like above. If you still cannot see your wireless interface, unload brcmfmac again and try reloading wl. Wait a few seconds and then list your network interfaces again. ![]() To do this, begin by ensuring that all Broadcom drivers have been unloaded. If the Linux loopback device is the only listed interface, you may need to load an alternative Broadcom driver. If you can see your wireless interface in the list, you should now be able to use wifi-menu to select and connect to your wireless network. You can list the network interfaces available from the installer environment by running ip link show. The b43 driver is also built-in to the kernel and included in the installation media, but it requires external proprietary firmware from the b43-firmware AUR package which will need to be downloaded from another machine connected to the internet. The broadcom-wl package is included in the Arch installer media, but may need to be manually enabled before the chipset will function correctly. Other BCM43XX chipsets may only be supported by a proprietary driver such as b43 or wl. If this is the case, you should have wireless available from the installer with no further configuration necessary. Depending on your model, you may have the Broadcom BCM43602, which is supported by the open source brcmfac module that is built-in to the Linux kernel and typically enabled by default. If you have neither, the only option is to use the onboard wireless adapter. For more information, see Android tethering. In case you use a Thunderbolt ethernet adapter, you may have to power on the machine with the adapter plugged in for it to be picked up by the system.Īnother easy option is to use USB tethering with an Android device. Thunderbolt Ethernet adapters and USB-to-Ethernet adapters are usually picked up automatically. ![]() You may wish to change this for a more legible font, an example of which is With the Arch installation media on a flash drive, you can boot it by holding down the Alt (or Option) key while your Mac starts up, and then selecting the applicable EFI Boot option when the Apple boot manager appears.Īs this model of notebook has a high DPI display, the console font displayed will be extremely small and depending on your preferences is likely to be uncomfortable to use. ![]() Please refer to the official Installation guide for more detailed instructions, as the following content mainly describes deviations from those instructions that are specific to this MacBook model.Īs this Mac model does not include a CD or DVD drive, you may wish to copy the Arch installation media onto a USB flash drive. Installation is similar to any other standard laptop. Please keep in mind that the volume of the startup sound can only be modified reliably in OS X. Just boot in OS X, mute your system sound and reboot again to the Arch Linux Installation media. Note: If you plan to remove OS X, it is advisable to disable the MacBook startup sound before proceeding with partitioning. If you plan on keeping OS X for the purpose of dual booting, you need to manually shrink the main OS X HFS+/APFS partition from within OS X's Disk Utility program.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |